“We want to reduce パチスロ わっしょい drying time for metal parts” KMβ

 Screw Metal パチスロ わっしょい

We want to reduce パチスロ わっしょい drying time for metal parts

A metal parts manufacturer, O Corporation, told us,“After cleaning パチスロ わっしょい workpieces (metal parts in complicated shapes), we remove water with a water remover but パチスロ わっしょい drainage is poor. Somehow we want to shorten パチスロ わっしょい drying time after water removal and increase パチスロ わっしょい water removal efficiency.”So we proposed and supplieda water remover for small parts.

As a result of using our centrifuge, we received パチスロ わっしょい evaluation thatパチスロ わっしょい time for パチスロ わっしょい drying process after water removal was shortened by as much as 34%, and work efficiency increased.

KM small

パチスロ わっしょい proposed KM water remover for use with small parts

Key Points – Original operation program

Reduced drying time by 34%.

We proposed an original operation program instead of パチスロ わっしょい usual water remover operation method.

Drying time was reduced by 34%.

When initially consulted, パチスロ わっしょい metal parts that we had checked were small at around 2 – 5 cm, and we felt,“Isn’t パチスロ わっしょいre a lot of water remaining even when a centrifugal force is applied?”

And so, to reduce パチスロ わっしょい water remaining, to enable a special movement in addition to パチスロ わっしょい usual operation method,we proposed an original program.

In addition to パチスロ わっしょい direction of rotation, by proposing a specification that enabled rotation in パチスロ わっしょい opposite direction, too, a complex movement occurred not a monotonous movement, and this device caused パチスロ わっしょい remaining water in パチスロ わっしょい cavities in パチスロ わっしょい small parts to fly out.

Work efficiency increase

パチスロ わっしょい water remover used until now had a motor and to make a special movement required re-wiring each time.

However, with our control method, that kind of troublesome work was not needed,and it was possible to cause a special movement with one touch of パチスロ わっしょい touch panel.

As a result, パチスロ わっしょい time used up for パチスロ わっしょい troublesome re-wiring task was not needed,and パチスロ わっしょい work efficiency greatly increased.

Labor costs reduced by saving on labor

パチスロ わっしょい program was assembled, and with パチスロ わっしょい touch panel パチスロ わっしょい movement wasautomatically controlled, anda timer can be set now.

Automatic operation is possible with timer control, leading toa reduction in labor costs due to labor savings.

After introducing our water remover for use with small parts,it is possible to remove more water easily than with パチスロ わっしょい usual water remover.

As a result, we received パチスロ わっしょい evaluation that after water removal,パチスロ わっしょい drying process was shortened by as much as 34%され、and work efficiency was increased.

Company supplied

パチスロ わっしょい metal parts manufacturer, O Corporation

Screw

Centrifuge supplied

KM small


For any questions or inquiries regarding centrifuges, feel free to contact Matsumoto Machine Sales, パチスロ わっしょい sales arm of パチスロ わっしょい pioneering centrifuge manufacturer.

パチスロ わっしょい